HMMWV General Support Tool Kit (GSTK) Kent Moore FSI SPX DRAF

HMMWV General Support Tool Kit (GSTK) Kent Moore FSI SPX DRAF Humvee Maintenance

Brands: Kent Moore, SPX, FSI, Proto, DRAF Industries, Starrett

Condition: New other (opened boxes)

Kit Type: HMMWV General Support Tool Kit (GSTK)

NSN#: 5180-01-389-7561

Below is an abbreviated inventory list. 

Draf 552 Power Steering System Analyzer, Draf Kent Moore J-39524 Pinion Setting Tool Kit, Draf SPX Kent Moore J-24385 Axle Housing Spreader, Draf Industries Automotive Belt Tension Gauge Model 371, FSI D100-MIL-1 HYDRAULIC BLIND RIVETER Kit, Kent Moore J-21370-6 Servo Pin Height Gauge J-21370-10 4 5 Band Apply Pins, Kent-Moore GM Transmission Bushing Service Set J-21465-A, Draf Kent Moore SPX Run Flat Tire Compression Tool, Kent Moore J-39084 6.5L Diesel Engine Rear Main Seal Installer, Kent Moore Univ. Bushing Bearing Seal & Gear Remover Puller Set J-29369 J-26941

 SPX Kent Moore J-8763-B Transmission Holding Fixture, SPX Kent Moore J-03289-20 Bench Mount Transmission Holding Fixture, Diesel Timing Tachometer Tester Tech-Time Model 3300-S DTI, Starrett Dial Indicator 25-141J Lug Back 0-0.25” Range / 0.001”, Draf Kent Moore J-35199 Pinion Setting Gauge Tool Kit, Kent Moore J-33149-A Axle Holding Fixture, Kent Moore SPX J-35178 Camshaft Bearing Remover Installer, Kent Moore SPX Compression Gauge J-6692-B and Adapter J-26999-30

Tie rod separator, Yoke Seal Installer (J-29162), Drive transmission handle (Draf 551), Power steering pump pulley installer (Draf 553), Geared hub input seal inserter (Draf 579), Geared hub seal inserter (Draf 580), Geared hub socket wrench (Draf 581), Governor weight support (J-16313), Pilot tube mandrel (J-16314), Replacement bushing kit (J-18411), Transfer pump end cap socket (J-20548), Clutch spring compressor adapter (J-21664), Rear bearing pinion remover (J-21786), Bearing/Bushing remover (J-21786), Slide Hammer adapter (SPX 8007), T27 Torx bit, Output shaft seal inserter (J-22661), Yoke seal installer (J-29162), Oil seal installer (J-21359), Seal inserter (J-33153), Clutch Spring Compressor (Draf 4670), Inner clutch alignment tool (J-24396), Bearing and bushing inserter (Draf 576), Hydraulic valve lifter remover (J-29834), Rack Piston steer gear punch (J-21552), Bearing/Brush remover (Draf 6221), Bearing/Brush inserter and remover (Draf 6278), and more transmission tools.

Proto 19mm 16mm 14mm crowfeet, Proto 9/16 5/8 11/16 7/8 15/16 crowfeet, Proto 6mm 7mm 8mm hex head sockets, Proto 1/8 5/32 1/4 5/16 hex head sockets, Proto 3/8" deep well socket, Kent Moore SPX J-25306 and J-35205 Torque wrench adapters, SPX J-35165 OTC E6 Torx socket, Draf (kent moore equivalent) 35169 diesel timing gage (some of these are metal, and some are red plastic), SPX J-35208 Elbow pipe to tube adapter, SPX J-35209 quick coupling. 

HMMWV Engine Lifting Bracket 6.2L 6.5L SLING LEVELING FIXTURE

The military paid over $14,250 for each of these kits. 

I will take additional pictures of any items you wish. Just message me.